Lubricating Greases and Oils: Consistency of Lubricating Greases • Corrosion Preventive Properties of Lubricating Greases • Dropping Point of Lubricating Grease • Dropping Point Ubbelhode • Evaporation Loss • Evaporation Loss of Lubricating Greases • Filterability of Lubricating Greases • Leakage Tendencies of Wheel Bearing Grease • Oil Separation from Lubricating Grease • Roll Stability of Lubricating Grease • Water Spray Resistance

---

Evaporation Loss of Lubricating Greases

ASTM D2595

Evaporation Loss of Lubricating Greases Over Wide-Temperature Range.
This test method covers the determination of evaporation loss of lubricating greases at temperatures between 93 °C and 316 °C (200 °F and 600 °F).
This test method is intended to augment Test Method D972, which is limited to 149 °C (300 °F).

---

LT/TB-205100/2-DM

Thermostatic Dry Bath, 2 places

• Two places aluminium block with double insulating wall
• Operating temperature up to + 320°C
• Digital thermoregulator, risolution 0.1°C, PT100 probe class A,
  over-temperature alarm and safety thermostat
• Digital display for air temperature control with thermocouple K
  for each single position
• Stainless steel heater controlled by PID system
• Two stand-by covers
• Remote control unit with cooling fan
• Two test places each with its flow meters 2 Lt/Min or 120 Lt/h
• Power supply: 220 Vac ±10% 50 Hz
• User manual
• Cord cable with shuko plug

---

LT/TB-205100/4-DM

Thermostatic Dry Bath, 4 places

• Four places aluminium block with double insulating wall
• Operating temperature up to + 320°C
• Digital thermoregulator, risolution 0.1°C, PT100 probe class A, over-temperature alarm and safety thermostat
• Digital display for air temperature control with thermocouple K for each single position
• Stainless steel heater controlled by PID system
• Four stand-by covers
• Remote control unit with cooling fan
• Four test places each with its flow meters 2 Lt/Min or 120 Lt/h
• Power supply: 220 Vac ±10% 50 Hz
• User manual
• Cord cable with shuko plug

---

Accessories for ASTM D2595

• LT/SP-302-SA: air pump
  • capacity: 5 l/min
  • max pressure: 0,3 bar
  • power supply: 220 Vac
• LT/EC-205100/M: set for product evaporation ASTM D2595 in stainless steel
  • flange for fixing to the block, 3 sealing screws and gasket
  • threaded axis for fixing the sample cup and calibrated internal hole to guarantee the correct vapors / pressure breather
• LAB-102-051: greases test cup with support
• T-AS3C: thermometer ASTM 3C

Spare Parts for ASTM D2595

• LAB-102-052/C: gasket, pack of 10 pcs.
• LAB-102-030: thermocouple support

---